Notifications

Clear all

This Forum is a place for Piper Comanche pilots to communicate and discuss technical issues

If you join or reset a password, please check your Spam Email box for emails from Admin at ComancheTechTalk.com

Please put your questions on the forum as well so everyone can read and respond. Someone else might be having similar questions.

All questions or topics on the Forums automatically get sent to the Tech team as well.

Instrument panel

Comanche Instruments and Avionics

Last Post by ICS archives 2008-2018 5 years ago

1 Posts

1 Users

0 Reactions

145 Views

RSS

ICS archives 2008-2018

Admin

Joined: 5 years ago

Posts: 1162

Topic starter 02/05/2020 7:40 pm

Instrument panel

by Todd Skalsky » Sun Jan 26, 2014 6:29 pm

Hi all,

I am wanting to install an engine monitor and am wondering if the panel in my 63 250 is two piece. I want to take the old tach and all gauges out but don't want to redo the whole panel at this time. Any advice will be appreciated.

Thanks,

Todd Skalsky

Todd Skalsky

Posts: 15

Joined: Mon Dec 06, 2010 4:50 am

Top

Re: Instrument panel

by N3322G » Mon Jan 27, 2014 1:26 am

Todd,

Depending upon what model you buy, it may or may not be STC'd to replace the gauges.

For our Twin, the JPI just took a slot and the panel was cut a little to accommodate. Ours is also a two piece.

Pat

Patricia Jayne (Pat) Keefer ICS 08899
PA-39 #10 Texas

N3322G

ICS member

Posts: 1911

Joined: Thu May 08, 2008 1:58 pm

Location: Fort Worth, Texas area

Top

Re: Instrument panel

by VANBLADEREN » Mon Jan 27, 2014 2:36 am

Your panel is really one piece with a floating section over the pilots yoke. You cannot remove the rest of the panel without cutting it away. I do not know what you have in your panel now, but if you can get it somewhere on pilots side somewhere, you would be most happy.

Regards

jvb

VANBLADEREN

ICS BOD member

Posts: 203

Joined: Fri Jun 01, 2001 8:55 pm

Top