This Forum is a place for Piper Comanche pilots to communicate and discuss technical issues
If you join or reset a password, please check your Spam Email box for emails from Admin at ComancheTechTalk.com
Please put your questions on the forum as well so everyone can read and respond. Someone else might be having similar questions.
All questions or topics on the Forums automatically get sent to the Tech team as well.
PA30 alternate air cable
Can the inner cable be removed from the outer housing and cleaned, inspect and slid back in, or is replacement the only option?
Thanks,
larry
- Larry Martin
- Posts: 38
- Joined: Wed Jul 13, 2016 6:51 pm
Re: PA30 alternate air cable
Can't answer your question but can tell you I got cables for this from McFarlane. Be sure to check alt air door operation and proper 1/8 in adjustment. It is a common failure area on Twins and results in bad things happening.
Patricia Jayne (Pat) Keefer ICS 08899
PA-39 #10 Texas
N3322G- ICS member
- Posts: 1911
- Joined: Thu May 08, 2008 1:58 pm
- Location: Fort Worth, Texas area
Re: PA30 alternate air cable
larry
- Larry Martin
- Posts: 38
- Joined: Wed Jul 13, 2016 6:51 pm
Re: PA30 alternate air cable
Patricia Jayne (Pat) Keefer ICS 08899
PA-39 #10 Texas
N3322G- ICS member
- Posts: 1911
- Joined: Thu May 08, 2008 1:58 pm
- Location: Fort Worth, Texas area
Re: PA30 alternate air cable
It could be done, you would have to straighten the engine end of the wire in order to remove it. Once pulled back about 4" be sure to catch the small steel ball from the cable. They can be lost easily, I know.
Clarence
- Clarence Beintema
- ICS member
- Posts: 134
- Joined: Tue May 11, 2010 11:41 pm
Re: PA30 alternate air cable
Any problem with cable break when bending it again?
- Larry Martin
- Posts: 38
- Joined: Wed Jul 13, 2016 6:51 pm
Re: PA30 alternate air cable
You can normally get away with it a few times. If the end does break, there is usually a little slack in the nacelle which you can gain.
Clarence
- Clarence Beintema
- ICS member
- Posts: 134
- Joined: Tue May 11, 2010 11:41 pm
Timothy Poole- Posts: 122
- Joined: Tue Oct 28, 2014 8:43 pm
- Location: KVKX