The stabilator of my aircraft (PA 24 260 C) has been stuck by a tug. The skin has been slightly bent and I look for the following parts number :

P/N 20193-22, SKIN- Stabilator top, left hand, Qté 1
P/N 20193-26, SKIN- Stabilator bottom, left hand, Qté 1
P/N 20193-24, STRIP - Stiffener, Qté 1

Does anyone know a supplier for these parts ?

Regards

Pierre Hulin
ICS 16134

I feel for you, and understand how you feel!

I had to change a wing panel recently because a Lear 35 came into my hangar uninvited, the panel was not available anywhere and it was custom made, there are a few places that do metal work and can do it for you.

Williams Airmotive is a very good place to start, if they can't help you, perhaps they can suggest somebody.

http://www.airframecomponents.com

Hope it works out

I would check with Webco to ask if they can make you a set. I am betting that they can. Of course, you can easily make them out of aluminum just by cutting them out of a suitable piece of aluminum. The service manual gives you the alloy and thickness of the skins.

You will want someone with a bit of sheet metal experience to do the repair. It is not too difficult, but it needs a few sheet metal specific tools.

v/r
Jim

Al Powers ICS 2978