Notifications

Clear all

This Forum is a place for Piper Comanche pilots to communicate and discuss technical issues

If you join or reset a password, please check your Spam Email box for emails from Admin at ComancheTechTalk.com

Please put your questions on the forum as well so everyone can read and respond. Someone else might be having similar questions.

All questions or topics on the Forums automatically get sent to the Tech team as well.

back seat help

Comanche Airframes

Last Post by Kate 5 years ago

1 Posts

1 Users

0 Reactions

127 Views

RSS

Kate

Admin

Joined: 5 years ago

Posts: 138

Topic starter 10/04/2020 2:11 pm

March 22, 2018 at 17:07 #103870 Trash | Reply

George Sheasley

Participant

I became the owner of a 1963 PA-30 Ser No.30-173 a while back. When I got the A/C the interior had been removed for a refurbishment and sitting in a pile. I managed to get everything back in except for the backseat center seat belt hook up and where the top of the seatback connects with the sidewall. The center seatbelt holder is a clevis and cable arrangement that is not available from Piper. What I need here is the length of this from the tiedown on the floor to the D ring of the seatbelt. Secondly, if you could send me a couple of pictures of how the top of the seatback is attached to the wall. I think that I have some parts to do this but I am not sure due to the fact that both the parts manual and the service manual do not cover these two items.

thanks in advance for your help.
George Sheasley
March 27, 2018 at 13:49 #103885 Trash | Reply

William Hughes

Participant

George:

I am a bit confused – you have a centre seat in the back?

William
March 27, 2018 at 15:20 #103886 Trash | Reply

George Sheasley

Participant

William:
Sorry, just one back seat. It is the stock bench seat setup. the back-seat seatbelt D rings are connected to the center floor board and the side walls by a clevis, cable, shackle arrangement. what I need is the total length of these connector pieces. Piper no longer has this part in stock and what I have to do is make them. The parts Catalog shows these items on page 1F1 items 32, 33, part No. 20868 and 20869. The other problem is how to connect the top part of the seat back to the cabin wall. I have the items (page 1F1 items 22 and 24) needed but a couple of pictures showing these are hooked up would really help.

Thanks
George Sheasley
March 28, 2018 at 07:23 #103889 Trash | Reply

Alan Breen

Participant

Hello George,

I can’t answer your question as our PA30 is a B model with the separate seats in the back.

The one suggestion I have is to look at a single of the same vintage as I expect they will have the same setup as you have.

Quote

26 Forums
1,397 Topics
1,718 Posts
0 Online
337 Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed